C8702, C8000, Frame controller – Junger Audio C8702 Controller C8000 User Manual
Page 15: Digital audio modular processing system

C8000
Frame Controller
C8702
digital audio
modular
processing system
15/22
modules firmware update
The MODULES FIRMWARE BULK UPDATE. Is no longer a function of the Frame Controller.
Pls. See C8702 Release Notes 1.14.00 (or higher) for details.
Important note! Before you update any module firmware you must update the Frame Controller if a new
image comes with the module firmware archive. Otherwise the Frame Controller may not show the GUI at
all or shows incorrect module control pages.
If there is the need for special firmware combinations or you don’t want to use the latest firmware for any
reason, as offered by the C8000 Bulk Updater software, you can make use of the
MODULE FIRMWARE SINGLE UPDATE function. This function gives you a drop down list of the
modules of a frame, their addresses and their actual firmware.
This is a basic tool and it needs a bit care when using it. You must update module by module and for each
module you must choose the respective part of the firmware.
Select module to update
[address:type actual firmware] module name
Select firmware to update
[Controller (*.bin)]
actual module controller firmware is indicated by C:xx
[DSP (*.can)]
actual DSP firmware is indicated by DSP:xx
[FPGA (*.pga)]
actual FPGA firmware by FPGA:xx
[SDI (*.sdi)]
actual SDI firmware is indicated by SDI:xx
Select firmware file
You must browse for the location of the respective file (where you have
unpacked the archive or where a single file received from Junger is
stored).
Important Note! It is not possible to select a firmware file from a packed folder. You must unpack an
archive in order to use the firmware file(s).