C8086, C8000, Digital audio modular processing system – Junger Audio C8086+ - Level Magic II ™ processor User Manual
Page 9: Enhanced 8 channel level magicii™ processor

Rev. 140416
digital audio
modular
processing system
C8000
Enhanced 8 channel Level MagicII™ processor
C8086+
9/16
SETUP (Operating Mode = 5.1 + 2)
For the 5.1 + 2 operating mode (selected at the DSP pane) the 8 processing channels will be shared
between a surround (5.1) and a stereo program. If the 5.1 downmix is activated the outputs 7/8 will
be occupied by the output of the downmix block and no extra stereo program processing will be
possible.
Here you can configure the DSP input assignment
of the surround processor and the operation of the downmix unit (pre / post 5.1 level magic)
as well as the input selection of the 2 channel (stereo level magic) audio processor.
You may change downmix parameters :
Downmix
Mode
[Mute / Mono / Lo/Ro]
the operating modes of the downmix processor.
Cmixlev
[-3 / -4,5 / -6dB]
center mix level.
Smixlev
[-3 / -6dB / OFF]
surround mix level.
To C8000 System Bus
the signal structure of the DSP expects a certain surround
channel assignment for its inputs (L, R, C, LFE, Ls, Rs).
The operator must know it and decide about the assignment of
signals coming from an upstream device.
If the "M" option is activated and Dolby Metadata is available
from the source, the blue labels of the "From C8000 System
Bus" box will show the physical channel assignment of the
source material.
The metadata related settings will only be shown if the "M" (metadata) option is activated.