Junger Audio C8086+ - Level Magic II ™ processor - Manual (Page 12)

Rev. 140416
digital audio
modular
processing system
C8000
Enhanced 8 channel Level MagicII™ processor
C8086+
12/16
Compressor
[On / Off]
Reference Level (dBFS) [-40 … 0]
Range (dB) [0 … 20]
Ratio [1.1 / 1.2 / 1.3 / 1.5 / 1.8 / 2.0 / 2.5 / 3.0 / 4.0 ]
Processing [live / speech / pop / uni / classic]
Proc Status Enable
[On / Off]
it is possible to monitor the gain change of the control process.
An error status will be provided if the average of the gain change
is equal to, or above, the Leveler Range setting for more than
10s. If this option is turned on, a soft LED of the GUI will turn
from red to green. This status information is combined for all
processed channels and is presented as a module status to an
external monitoring system by sending a SNMP trap and/or by
firing a GPO. The parameter itself is also available for polling.
Bit Transparent
[off / on / auto]
for pairs of input signals it is possible to switch the signal path
into "bit transparent" mode. This allows to path non audio
signals (e.g. Dolby E) through the processor
without destroying it.
off
– not transparent for Non Audio signals
on – transparent for Non Audio signals, no processing
auto – automatic switch over to transparent if a Non Audio
signal is detected at the input.
Expert
[On / Off]
Clear Processing History [clear]
(Preset) hold down the soft button to clear the history. Tick the
checkbox if the preset must clear the processing history.
Initial Dynamic Gain (dB) [-40 … 40]
AGC Recovery [normal / fast]
Low Level Behavior
Processing Threshold (dBFS) [-80 … -20]
Below Threshold Mode [release / hold]