Junger Audio C8086+ - Level Magic II ™ processor - Manual (Page 14)

Rev. 140416
digital audio
modular
processing system
C8000
Enhanced 8 channel Level MagicII™ processor
C8086+
14/16
The Junger proprietary Level algorithm offers more detailed linking options since it is not related to
program loudness measurement rules (ITU, ARIB, ATSC, EBU) but operating level oriented control.
BUS ROUTING
Here you may assign the audio signals from C8000 audio busses to the processing channels
Ch 1/2 … Ch 7/8 of the DSP.
About "MixMux" : You may select if the input audio signals to the C8086+ must be taken from a
source that delivers it in 8 channel (time division) multiplex (Mux) or in 2 channel (time division)
multiplex or you may select a mixture (Mix) of both formats.
from C8000 System Bus The audio busses from the C8k frame must be assigned to the
respective processing channels. If the module is connected to a
bus that is in 8ch mux mode (e.g. S17), all signal pairs my be taken
from there or from an individual 2ch mux buss (e.g. S8).
Main Input (Bank A) you may select a set of 8 signals as the main input for the DSP.
Alternative Input (Bank B) you may select a set of 8 different signals as an
alternative input.
to C8000 Bus here you select which mux format is used for the module output
channels. You may move all 8 on one bus (e.g. S19) or in
parallel in 2ch mux for selected signals (e.g. S21).
Enable C8000 Bus Driver [Off / On]
for setup and maintenance applications one my turn off all
32 bus drivers (set it to tri state mode) to avoid interference with
other modules of the same frame.