Junger Audio C8000 System - Manual (Page 8)

digital audio
modular
processing system
C8000
system configuration
2/7
Below is an example of a module carrier board for an old processing module:
On the left hand side you see the rotary encoders. They have 16 settings (0 to F) to select one of the
bus lines S1 to S16. If you need access to bus lines higher than 16, you must replace the adjacent range
jumper labeled: “+16”. Now the rotary encoder will select bus lines S17 (0) to S32 (F).
For two channel devices the rotary encoder labeled “IN-1” and jumper row labeled “OUT1” are used. For 4
channel devices the rotary encoders labeled “IN-1” and “IN-2” and jumper rows labeled “OUT1” and “OUT2”
are used, and so forth.
! On some modules the IN4 rotary encoder and the range jumper are used to setup special
application modes (see respective manual for details).
ADDRESS
Input bus number S1 (0) to S16 (F)
OUT
CAN address (ID) 0 - F