Junger Audio C8000 System - Manual (Page 10)

digital audio
modular
processing system
C8000
system configuration
4/7
Nearly the same applies to the C8402/03/04 SDI Embedder / De-Embedder with slightly different
DIP-switch labeling:
The MODE DIP-switch allows for setting of the operating modes:
If DIP-switch #1 is set to MASTER, the module provides the necessary clocks for audio signal distribution for
the C8k frame. In this case the Sync-Module must be removed!
You must use the frame controller to configure the board. Therefore the DIP-switch #2 must be set to
REMOTE=ON. All settings after power up are taken from an NV (non volatile) memory and the remote
control via the Frame Controller is enabled.
If the upper DIP-switch #3 is set to BUS-EN=ON, the bus configuration will be taken from the
NV memory after power up. If an unknown bus configuration is stored, it can cause a conflict with other
modules inside the frame (short cuts between several outputs).
TDM=ON enables the multiplexing of eight audio channels on one bus line.
The CAN/BUS DIP-switch determines the CAN-bus address of the module in hexadecimal values
from 0 – F. The coding is binary (D0=LSB, D3=MSB).
Older versions had a few more DIP-switches for hardware based settings of the Embedder and
the De-Embedder.