7 system tab – Doremi GENeration3D User Manual
Page 34

6.7 System Tab
•
The "System" tab is illustrated below:
Figure 20: Doremi Universal Interface GUI – System Tab
Note: All parameters are explained in this manual in Section 3 “Generation 3D Front Panel
Controller.”
•
In addition, the "System" tab can be used to perform the following actions:
•
Save: To save the current settings to flash, click on the “Save Settings” button (Figure 20).
•
Restore: To restore the Generation 3D back to the factory default settings, click on the
“Restore Factory Settings” button (Figure 20).
•
Firmware Upgrade: To perform a firmware upgrade, click on the “Firmware upgrade
(Current: x.yy)” button (Figure 20).
Note: The "Firmware upgrade" button provides the current firmware version installed on the
connected unit. It is shown after “Current:” On the image above (Figure 20), the current firmware is
version 1.2.15. See Section 7.1 for detailed upgrade steps.
G3D.OM.002067.DRM
Page 34
Version 1.3
Doremi Labs
"Save
Settings"
Button
"Firmware
upgrade"
Button
Generation 3D
Temperature
"Display Logs"
Button
"Restore
Factory
Settings"
Button