Dataman S6 - Manual (Page 4)

Dataman-S6 - User's Manual
Chapter 1 Product Description
1-1 Introduction
With 30 years experience Dataman is the world’s leading provider of device programmers. We offer
a comprehensive range of programming solutions suitable for every requirement from design and
development to large scale production.
We are committed to providing continued development, manufacturing and support and to deliver
customer specific innovative solutions.
All Dataman products come with comprehensive warranties, free lifetime support and free software
updates via our website and telephone helpdesk.
1-2 Safety Information
All the operations, maintenance and repair services are required to follow the below safety
information. We do not take responsibility for unexpected problems by misusing the equipment.
1. The programmer must be connected to the host computer using the supplied Y type USB
cable. Check that both USB plugs are connected to the computer and confirm that the
available USB power is sufficient to operate the programmer correctly. If the computer is
connected through a USB Hub it will need to be a powered hub (+5V/1A or above).
2. Do not operate the product near flammable gases. High-temperatures and humidity should
also be avoided.
3. Do not remove the product's case to adjust or replace any internal parts.
4. Sockets or adapters are considered consumables. The life time is determined from the
frequency of use specified in the manufactures specification. If a socket is used beyond the
rated number of actuations specified by the manufacturer, the socket will start to give errors
caused by poor contact. This will result in an increasing number of contact errors and burn
failures.
5. When using this product as mass production or production for master tape, please take the
appropriate testing precautions before assembling the completed product. All the risks
attributed to using the product or operating the software are undertaken by the user.
6. This manual is for reference and preservation of the consumer. Product specifications and
manuals are subject to change without notice.
7. The company or trademarks mentioned in this manual are the property of their respective
owners.
1-3 Precautions
1. When you work with your IC using our programmer it will access the device using a high
frequency signal. To ensure proper programming and high yield rates you must observe the
following:
a) During any operation with the IC (read / verify / programming / erase / blank check ...
etc) do not touch the IC or ZIF socket. When inserting an IC into the ZIF socket,
please take note of basic electrostatic protection measures.
1