Hotplug operation – CRU HotPlug Field Kit User Manual

Page 3

Text mode
Original mode

WiebeTech

H o t P l u g - E u r o V e r s i o n U s e r M a n u a l ( A 9 - 0 0 0 - 0 0 3 6 R E V . 1 . 1 )

- 3 -

HotPlug Operation

Unplug any cables connected to the power strip that are not connected to the device(s) you want to
capture.

Ensure the HotPlug power switch is in the OFF position.

Plug the input line cord into the HotPlug unit (receptacle labeled “IN”).

Plug the other end of the input line cord into the UPS. The HotPlug power switch will glow red,
indicating that HotPlug is receiving power.

Find an open connection on the power strip. Connect one end of the output line cord into the power
strip, and then the other end into the receptacle labeled “OUT” on HotPlug. The red LED (output
power indicator) will light.

NOTE: Many UPSs have both
surge-protected and battery-
powered outlets. Be sure to
use HotPlug with UPS outlets
that supply battery power.

UPS

HotPlug