CRU RTX100-INT - Manual (Page 2)

RTX220 QR - Manual
4. HDD Installation
RTX100-INT features TrayFree™ technology, so installing a hard drive couldn’t be
easier!
a. Pull the ejection handle, open the door.
b. Slide in your SAS or SATA hard drive, connector-end first.
c. Shut the door until you hear it click.
For extra security for your hard drive you can lock the bay, but make sure to unlock it
before pulling on the ejection handle again, or damage could occur.
Your RTX is now ready to use!
If your drive is already formatted, you can begin using it right away. New hard drives
will need to be formatted before they can be used.
2. Identifying Parts
Take a moment to familiarize yourself with the parts of the RTX100-INT. This will help you
to better understand the remaining instructions.
Rear View
3. Installation Steps
a. Mount RTX100-INT into your computer. In an open 5 ¼” bay in your computer.
Install the RTX100-INT just as you would a CD/DVD ROM.
b. Plug in the data cable. The RTX100-INT connects to your computer through
SATA. One end of the cable connects to the back of the unit. Insert the other end
into an available port on your computer’s motherboard or add-in card.
c. Plug in the power. Take an unused 4-wire Molex power connector from inside
your computer and attach that to the adapter cable that is included. Plug the
4-wire power cable from the adapter to the bride board on the rear of the unit.
Bridge board power connection SATA power connection
Lock
Ejection
Handle
LEDs
SATA Data connection
Front View