CRU RAX210-3QJ - Manual (Page 5)

5
Protecting Your Digital Assets TM
CRU Configurator User Manual
If you are using a Gmail email address without two-step verification enabled,
Google will automatically block sign-in attempts from non-Google applications
because they are not part of the Google ecosystem, and therefore character-
izes these applications as ‘less secure’. Log in to your Google account via a web
browser and navigate to https://www.google.com/settings/security/lesssecure-
apps , and then under “Access for less secure apps” choose Enable . Then click
the Done button to save your settings.
2.5.2 RAID Device Settings
This section allows you to modify and customize all alarms and temperature thresh-
olds that are measurable in all CRU QR and 3QR RAID devices.
Before you can modify the RAID Device Settings, you must remove any drives
inserted into your CRU device and connect the device to your computer with a
USB 2.0 cable. Always power off your device before removing drives!
Buzzers Tab
The Buzzers Tab allows you to enable or disable audible buzzers on the device.
Place a check in the box next to the type of event in order to trigger the audible
buzzer when it occurs:
• System Warning: A drive exceeds the warning temperature threshold.
• System Alarm: The drive and/or enclosure exceeds its alarm temperature
threshold or the device fan fails.
• RAID Warning: The RAID is degraded or rebuilding.
• RAID Alarm: The RAID is invalid or has failed.
Thresholds
The Thresholds Tab allows you to modify the temperature thresholds for the
enclosure alarm, drive warning, and drive alarms. You can also modify the tem-
perature at which the fan turns on.
2.5.3 Log Tab
The Log Tab creates a record of each event that has been triggered. Click the Reset
button to clear all active alerts and alert history.
2.6 SETTINGS TAB
The Settings Tab allows you to modify how Configurator behaves. When finished, click
Save to save the settings. Click the Use Defaults button to reload the default settings.
Device Detection
By default, only CRU devices are shown in the drop-down box on the Configurator
Bar. Remove the checkbox to show all storage devices that are directly connected
to your computer.
Figure 5. The Buzzers Tab.
Figure 6. The Thresholds Tab.
Figure 7. The Settings Tab.
NOTE
NOTE