CRU DE75 ATA/133 - Manual (Page 2)

Rugged, Reliable, Mobile, Secure
TM
1-800-260-9800 www.CRU-DataPort.com
Note: The lock on the Data Express serves as a power
switch. It must be engaged (turned counterclockwise) for the
Data Express to power up and function properly.
Limited Product Warranty
CRU-DataPort (CRU) warrants the Data Express DE75 to be free
of significant defects in material and workmanship for a period of
five years from the original date of purchase. CRU’s warranty is
nontransferable and is limited to the original purchaser.
Limitation of Liability
The warranties set forth in this agreement replace all other war-
ranties. CRU expressly disclaims all other warranties, including but
not limited to, the implied warranties of merchantability and fit-
ness for a particular purpose and non-infringement of third-party
rights with respect to the documentation and hardware. No CRU
dealer, agent or employee is authorized to make any modifica-
tion, extension, or addition to this warranty. In no event will CRU
or its suppliers be liable for any costs of procurement of substi-
tute products or services, lost profits, loss of information or data,
computer malfunction, or any other special, indirect, consequen-
tial, or incidental damages arising in any way out of the sale of,
use of, or inability to use any CRU product or service, even if CRU
has been advised of the possibility of such damages. In no case
shall CRU’s liability exceed the actual money paid for the products
at issue. CRU reserves the right to make modifications and addi-
tions to this product without notice or taking on additional liability.
Certification
EMI Standard: FCC Part 15 Class B, CE
EMC Standard: EN55022, EN55024
FCC Certification
This device has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC rules. Operation is subject to the following two condi-
tions:
1. This device may not cause harmful interference.
2. This device must accept any interference received; includ-
ing interference that may cause undesired operation.
Register your product at www.CRU-DataPort.com
A7-075-0004 Rev. 2.1
However, the appropriate jumper setting must still be configured
on JP6 (ID0 & ID1) located on the receiving frame motherboard
(Figure 2). For Master setting, install jumper on ID0 (Pins 1 & 2).
For slave setting, install jumper on ID1 (Pins 3 & 4).
Skip the Method 2 section and continue with installation.
Method 2
Using the hard-wire connector JP3 on the drive carrier circuit
board to allow drive carrier interchangeability between Master/
Slave configured receiving frames
To allow this interchangeability it is necessary to set the Mas-
ter/Slave drive selection by a hard-wire connection between the
drive and the drive carrier circuit board.
This method requires the fabrication of a cable wire (not pro-
vided). Refer to the DE75i-A100 Manual for further information
regarding Method 2.
Unit ID Select Switch Settings
The following table lists the unit ID select switch settings and the
valid AT/IDE unit numbers. Invalid switch settings are indicated by an
“X” and will result in a blank display in the receiving frame window.
Unit ID Select Switch Settings
Note: The unit ID number display is for ID display purposes
only. The master/slave setting must still be set on the drive
itself (refer to the drive manufacturer’s documentation for
further information).
Selecting the Unit ID Number: Use the alignment tool (pro-
vided) to select the ID number of the disk drive.
Unit ID Select
Switch Location
Unit ID
Select Switch
Alignment Tool