CIRCUTOR computer MAX f Series - Manual (Page 16)

M066B01-03-15A computer MAX 6f 12Vdc
- 15 -
6 DEVICE MENU AND CONFIGURATION PROCEDURE.
6.1 Entering the setup menu.
To enter the setup menu of the unit, press and hold button for more than 1 s. (This is called a long
keystroke in table 6.1, which gives a summary of the adjustment procedure). The pointer begins
flashing and points to the parameter that is going to be adjusted. Use buttons to select the
parameter to be adjusted.
The unit only switches to adjustment or configuration mode if all the capacitors are disconnected.
Otherwise, the button
must be pressed and held down during the full capacitor disconnection
sequence, which will be done with 1 s delays. After the disconnection process ends, the regulator enters
the adjustment menu. The navigation diagram can be found in Table 6.1 and the details on the
adjustable parameters and their adjustment possibilities are shown in Section 5.1.