Casella CEL CEL-35X dBadge - Manual (Page 11)

Casella CEL-35X dBadge Users Handbook – Page 11
4 CHARGING THE CEL-35X
4.1 Charging
The CEL-35X dBadge uses internal NiMH batteries. Ensure the CEL-
35X is fully charged prior to use by placing in the charger as shown in
Figure 5. Note the CEL-35X will fit into charger units regardless of
which mounting clips are attached.
Figure 5
Ensure the power supply (-PC18) is connected and the supply is
switched on. The CEL-35X dBadge will automatically switch on
during charging and display how much charge is within the dBadge,
as shown in Figure 6. When the CEL-35X dBadge is charging the
red LED will flash and the charge symbol will rotate on the top right
of the display. The dB
adge will display „Full‟ once charging is
complete and the LED on the front of the instrument will turn blue.
This should take approximately 1.5 hours from a discharged state. A
charging time of about 30 minutes will be sufficient to perform greater
than 8 hours of measurement. Once fully charged, the CEL-35X
holds enough charge to run for approximately 28 hours.
Figure 6
CHARGING
27
Hrs
FULL
28
Hrs