BIXOLON SRP-350plusIII - Manual (Page 16)

Rev. 1.03 - 16 -
SRP-350/352plusIII
1-4-3 Bluetooth Interface
• DIP Switch 1
SW Function ON OFF Default
1-1 Auto Line Feed Enabled Disabled OFF
1-2 Reserved - - OFF
1-3 Reserved - - OFF
1-4 Reserved - - OFF
1-5 Bluetooth mode iOS Normal OFF
1-6 Reserved - - OFF
1-7 Reserved - - ON
1-8 Reserved - - OFF
• DIP Switch 2
SW Function ON OFF Default
2-1 Reserved - - OFF
2-2 Reserved - - OFF
2-3 Internal Bell Control Disabled Enabled OFF
2-4 Auto Cutter Selection Disabled Enabled OFF
2-5
Printing Density Refer to the following Table 2
OFF
2-6 OFF
2-7 Near End Sensor Control Disabled Enabled OFF
2-8 Auto External Buzz Enabled Disabled OFF
• Table 1 – Baud rate (bps) Selection
Transmission Speed 1-6 1-7 1-8 Default
2400 ON OFF OFF
9600
4800 ON OFF ON
9600 OFF ON OFF
19200 OFF OFF OFF
38400 OFF ON ON
57600 OFF OFF ON
115200 ON ON ON
• Table 2 – Print Density Selection
Printing Density 2-5 2-6 Default
Level 1 OFF OFF
- Level 1 is default
- Level 4 darkest
Level 2 ON OFF
Level 3 OFF ON
Level 4 ON ON