Applied Motion TSM17P-1AG - Manual (Page 18)

18
Rev. A
920-0086
TSM17P Hardware Manual
4 Troubleshooting
LED Error Codes
The TSM17P uses red and green LEDs to indicate status. When the motor is enabled, the green
LED flashes slowly. When the green LED is solid, the motor is disabled. Errors are indicated by
combinations of red and green flashes as shown below. This feature can be disabled for certain
warnings but not for alarms. See software manual for information on how to do this and which
warnings may be masked.
Code Error
solid green motor disabled
flashing green motor enabled
1 red, 1 green position limit
1 red, 2 green drive disabled
2 red, 1 green ccw limit
2 red, 2 green cw limit
3 red, 1 green over temperature
3 red, 2 green internal voltage bad
3 red, 3 green non-volatile memory error
4 red, 1 green over voltage
4 red, 2 green under voltage
4 red, 3 green non-volatile double error
5 red, 1 green over current
5 red, 2 green current limit
6 red, 1 green open winding
6 red, 2 green encoder failure
7 red, 1 green communication error
7 red, 2 green save failed