Applied Motion STR2 - Manual (Page 4)

4
STR2 Hardware Manual 920-0059B
1/30/2014
• In operation, depending on the degree of enclosure protection, the product can have bare
components that are live or have hot surfaces. Control and power cables can carry a high volt-
age even when the motor is not rotating.
• Never pull out or plug in the product while the system is live. There is a danger of electric arc-
ing and danger to persons and contacts.
• After powering down the product, wait at least ten minutes before touching live sections of
the equipment or undoing connections (e.g., contacts, screwed connections). Capacitors can
store dangerous voltages for long periods of time after power has been switched off. To be
safe, measure the contact points with a meter before touching.
Be alert to the potential for personal injury. Follow the recommended precautions and safe
operating practices. Safety notices in this manual provide important information. Read and be
familiar with these instructions before attempting installation, operation, or maintenance. The
purpose of this section is to alert users to possible safety hazards associated with this equip-
ment and the precautions that need to be taken to reduce the risk of personal injury and dam-
age to the equipment. Failure to observe these precautions could result in serious bodily injury,
damage to the equipment, or operational difficulty.