Applied Motion STR2 - Manual (Page 3)

3
STR2 Hardware Manual 920-0059B
1/30/2014
Safety Instructions
Only qualified personnel are permitted to transport, assemble, commission, and maintain
this equipment. Properly qualified personnel are persons who are familiar with the transport,
assembly, installation, commissioning and operation of motors, and who have the appropri-
ate qualifications for their jobs. The qualified personnel must know and observe the following
standards and regulations:
IEC 364 resp. CENELEC HD 384 or DIN VDE 0100
IEC report 664 or DIN VDE 0110
National regulations for safety and accident prevention or VBG 4
To minimize the risk of potential safety problems, you should follow all applicable local and na-
tional codes that regulate the installation and operation of your equipment. These codes vary
from area to area and it is your responsibility to determine which codes should be followed,
and to verify that the equipment, installation, and operation are in compliance with the latest
revision of these codes.
Equipment damage or serious injury to personnel can result from the failure to follow all ap-
plicable codes and standards. We do not guarantee the products described in this publica-
tion are suitable for your particular application, nor do we assume any responsibility for your
product design, installation, or operation.
• Read all available documentation before assembly and commissioning. Incorrect handling
of products in this manual can result in injury and damage to persons and machinery. Strictly
adhere to the technical information on the installation requirements.
• It is vital to ensure that all system components are connected to earth ground. Electrical safety
is impossible without a low-resistance earth connection.
• The STR2 contains electrostatically sensitive components that can be damaged by incorrect
handling. Discharge yourself before touching the product. Avoid contact with high insulating
materials (artificial fabrics, plastic film, etc.). Place the product on a conductive surface.
• During operation keep all covers and cabinet doors shut. Otherwise, there are deadly hazards
that could possibility cause severe damage to health or the product.