Applied Motion ST10-C-CE - Manual (Page 37)

37
ST5/10-Si,-Q,-C, IP Hardware manual 920-0004 Rev. F
6/10/14
Holding Drive Rotor
Part Torque Current Setting Resistance Inductance Inertia
Number oz-in kg-cm amps ohms mH g-cm 2
HT��-���/��� �.� �.�� �.� �.� �.� �
HT��-���/��� ��.� �.�� �.� �.� �.� ��
����-���/��� ��.� �.�� �.� �.� �.� ��
HT��-���/��� ��.� �.�� �.� �.� �.� ��
HT��-���/��� ��.� �.�� �.� �.� �.� ��
HT��-���/��� ��.� �.�� �.� �.� �.� ��
HT��-���/��� ��.� �.�� �.� �.� �.� ���
HT��-���/��� ��� ��.� �.� �.� �.� ���
HT��-���/��� ��� ��.� �.� �.� �.� ���
HT��-��� ��� 25.48 6.0 0.5 2.2 750
HT��-��� ���.� 8.87 3.36 0.73 1.6 260
HT��-��� ��� 12.74 4.8 0.43 1.1 450
HT��-��� ��� 25.48 4.8 0.65 2.4 900
HT��-��� ��� ��.� ��.� �.�� �.� ����
HT��-��� ���� ��.� �.� �.�� �.� ����
HT��-��� ���� ��� ��.� �.�� �.� ����
HT��-��� 396.5 28.55 7.56 0.24 1.7 1100
HT��-��� 849.6 61.18 7.56 0.33 2.7 1850
HT��-��� 1260 90.75 6.72 0.63 5.4 2750
Note: The “Drive Current Setting” shown here differs from the rated current of each motor because the rated
current is RMS and the drive current setting is peak sine. If you are using a motor not listed here, for best
results set the drive current at the motor’s rated current x 1.2.
Recommended Motors