Optoma EX855 - Manual (Page 15)

English
5
Installation
Powering Off the Projector
. Press the “ Standby ” button on the remote control or “Off” on the
control panel to turn off the projector.
The following message will be displayed on the screen.
Press the “ Standby ” button on the remote control or “Off” on the
control panel again to confi rm otherwise the message will disap-
pear after 5 seconds. When you pressing for the second time,
the projector will shut down.
2. The cooling fans continue to operate for about 60 seconds for
cooling cycle and the POWER LED will fl ash Blue. When the
POWER LED turns red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait until
the projector has completed the cooling cycle and has entered
standby mode. Once in standby mode, simply press the “ ” but-
ton either on the rear of the projector or on the remote control to
restart the projector. 2
3. Power off the switch. 3
4. Disconnect the power cord from the electrical outlet and from the
projector.
5. Do not turn on the projector immediately following the power off
procedure.
1 3
2