Optoma W401 - Manual (Page 23)

23
English
User Controls
Using the Control Panel
POWER
Refer to the “Power On/Off the Projector” section on
pages 17-18.
RE-SYNC
Automatically synchronize the projector to the input
source.
Enter Confirm your item selection.
SOURCE Press “SOURCE” to select an input signal.
Menu
Press “Menu” to launch the on-screen display
(OSD) menu. To exit OSD, Press “Menu” again.
Help
Help Menu (only available when OSD menu is not
shown).
Four Directional
Select Keys
Use to select items or make adjust-
ments to your selection.
Keystone
Use to adjust image distortion caused
by tilting the projector. ( ±40 degrees)
Lamp LED Indicate the projector’s lamp status.
Temp LED Indicate the projector’s temperature status.
ON/STAND-
BY LED
Indicate the projector’s status.
Control Panel
Control Panel & Remote Control
POWER ?