Powering on/off the projector, Powering on the projector, Installation – Optoma W401 User Manual
Page 17
17
English
Installation
POW
ER
SOUR
CE
Powering On/Off the Projector
Turn on the projec-
tor first and then
select the signal
sources.
Powering On the Projector
1. Remove the lens cap.
2. Securely connect the power cord and signal cable. When
connected, the ON/STANDBY LED will turn Amber.
3. Turn on the lamp by pressing “ ” button either on the top of
the projector or on the remote. The ON/STANDBY LED will
now turn Green.
The startup screen will display in approximately 10 seconds.
The first time you use the projector, you will be asked to
select the preferred language and power saving mode.
4. Turn on and connect the source that you want to display
on the screen (computer, notebook, video player, etc). The
projector will detect the source automatically. If not, push
menu button and go to “OPTIONS”.
Make sure that the “Source Lock” has been set to “Off”.
If you connect multiple sources at the same time, press the
“SOURCE” button on the control panel or direct source keys
on the remote control to switch between inputs.
POWER
?
Lens Cap
1
Power
2
When Power mode
(Standby) is set
to Eco (<0.5W),
the VGA output,
Audio pass-through
and RJ45 will be
deactivated when
the projector is in
standby.