Optoma EH415 - Manual (Page 99)

English
99
Appendices
Command Description
Remark
(Parameter)
Config-URL Device’s IP address
LAN IP address is shown up if
LAN IP address is valid.
Wireless LAN IP address is
shown up if Wireless LAN IP
address is valid.
http://xxx.xxx.xxx.
xxx/index.html
Revision The revision must follow a
major.minor.micro scheme.
The revision is only increased
if the command protocol is
modified.
1.0.0
• For wide screen resolution (WXGA), the compatibility
support is dependent on Notebook/PC models.
• This AMX function is only to support AMX Device
Discovery.
• The broadcast information only send out through valid
interface.
• Both LAN and Wireless LAN interfaces could be
supported at the same time.
• If “Beacon Validator” was used. Please take care below
information.
PJLink™ supported commands
The table below shows commands to control the projector
using the PJLink™ protocol.
Command Description Remark (Parameter)
Command Description Remark (Parameter)
POWR Power control 0 = Standby
1 = Power on
POWR? Inquiry about the
power state
0 = Standby
1 = Power on
2 = Cooling down
3 = Warming up
N
ote
N
ote