Pilz PIT m3.1p - Manual (Page 35)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-7
7.6 Diagnostics
7 Operation
7.6 Diagnostics 7600 Diagnostics 7- Diagnose BAWS
For monitoring and diagnostics of the operating mode selector switch
4 back-lit buttons and 4 signal outputs are available. The outputs report
status information, which is divided into the following information class-
es:
 Selected operating mode
 Set authorisation
 Messages (e.g. user error and fault)
The status information can be evaluated through a control system.
The back-lit buttons indicate the operating mode selected on the oper-
ating mode selector switch.
7.6.1 Signal outputs for status information
Signal outputs for status information 7- Meldeausgänge Statusinformation BAWS
The status information indicates the actions performed by the operator.
These actions are: actuator connected, actuator removed and operating
mode selected.
NOTICE
If OM is selected (SI3:0=8h ... Bh) information remains active
indefinitely. All other information stays active for just 200 ms.
After that time the selected operating mode is again displayed.
Status information SI 3 (MSB) SI 2 SI 1 SI 0 (LSB) SI3:0= [hex]
Reserve 0 0 0 0 0h
Reserve 0 0 0 1 1h
Reserve 0 0 1 0 2h
Reserve 0 0 1 1 3h
Key Mode 1 - connected 0 1 0 0 4h
Key Mode 2 - connected 0 1 0 1 5h
Key Mode 3 - connected 0 1 1 0 6h
Key Mode 4 - connected 0 1 1 1 7h
OM1 selected 1 0 0 0 8h
OM2 selected 1 0 0 1 9h
OM3 selected 1 0 1 0 Ah
OM4 selected 1 0 1 1 Bh
No authorisation 1 1 0 0 Ch