MagnaFlow AUDI S4 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: Begin removing your OEM exhaust
system by first loosening the clamps at the
outlet of the catalytic converters. Working front
to rear detach all hangers from the rubber
isolators. Remove the system from the vehicle.
Step 2: Install your new MAGNAFLOW system
by first attaching the inlet pipes of the Inlet Pipe
Assembly to the catalytic converter outlets.
Locate the hanger to the rubber isolator. Next,
slip the inlet of the Muffler Assembly over the
Inlet Pipe Assembly and secure with the
supplied clamp. Locate the remaining hangers
into the rubber isolators.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between
the exhaust system and any body panels to
prevent heat-related body damage or fire.)
Step 4: Once a final position has been chosen
for the new system, evenly tighten all fasteners
from front to rear. The supplied band clamps
must be VERY tight to properly align the pipes
and prevent leaks (Approximately 65ft-lbs).
U-bolt clamps should be tightened to
approximately 30-35ft-lbs. inspect all fasteners
after 25-50 miles of operation and retighten if
necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
16585
2000-2002 Audi A4/S4 2.7L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Dec 14, 2009
Rev: 000
INLET PIPE
ASSEMBLY
MUFFLER
ASSEMBLY
2.50" CLAMP