MagnaFlow DODGE CHALLENGER SRT-8 HEMI Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1:(Carefully read all instructions before
installation) You will need to cut the existing exhaust
system in order to install your new MAGNAFLOW
exhaust. Measure and mark before you make a
square cut on both pipes 10 3/4" behind the hanger
weld points (Fig 1.)
Step 2: Remove all welded hangers from rubber
insulators making sure to retain the mounting
hardware and rubber insulators as they will be used
to install your new system.
Remove the tips from the exhaust by loosening all
the assembly clamps .
Step 3: Begin installation of your new system by
slipping the driver and passenger side Muffler
Sub-Assemblies onto the cut OEM pipes, attaching
the hangers to the OEM rubber insulators and
attaching loosely with the supplied 3.00" clamps.
Step 4: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 5: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
16881
08'-14' Dodge Challenger SRT8 - 6.1/6.4L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Sept 05, 2012
Rev: 000
Technical Support: 1-800-959-9226 Ext. 4500
Fig 1.
D/S MUFFLER
ASSY
P/S MUFFLER
ASSY
2X 3.00" CLAMP