MagnaFlow CHRYSLER 300C SRT-8 HEMI Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) To begin removal of the OEM system,
unbolt and remove the two exhaust cross members
located just forward of the OEM muffler assembly.
Loosen the clamps at the outlets of the catalytic
converters. Working front to rear remove all
clamps and disengage the welded hangers from the
rubber isolators. Do not damage the OEM rubber
isolators, as they will be re-used to mount the new
exhaust system.
Step 2: Begin installation of the new system by
fastening the two Inlet Pipes to the catalytic
converter extensions using the supplied 2.75"
clamps. Leave all clamps and fasteners loose for
final adjustment of the complete system. Install the
Main Muffler Assembly using the supplied 3.00"
clamps and by fitting the welded hangers into the
OEM rubber isolators. Install the driver's and
passenger's Tail Pipe Assemblies in a similar
fashion. When reinstalling the cross members use
the supplied spacers to allow for clearance.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between the
exhaust system and any body panels to prevent
heat-related body damage or fire.)
Step 4: Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (approximately 40ft-lbs). U-bolt clamps
should be tightened to approximately 30 - 35ft-lbs.
Inspect all fasteners after 25-50 miles of operation
and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15069
2012 Chrysler 300C SRT-8 6.4L Hemi
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Sep 26, 2012
Rev: 000
(2) 2.75" Clamps
(2) Front Spacers
(2) Inlet Pipes
Main Muffler Assy.
(2) Rear Spacers
(4) 3.00" Clamps
D/S Tail Pipe Assy.
P/S Tail Pipe Assy.