MagnaFlow DODGE TRUCK DURANGO Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before installation)
Remove the OEM system from the vehicle by first
unbolting the flanges attaching the inlet pipes to the
catalytic converters. Working front to rear remove all
mounting hardware and detach hangers from rubber
isolators. Be sure to retain all mounting hardware and
rubber as it will be needed to install your new
MAGNAFLOW performance exhaust system.
Step 2: Begin installation of your new exhaust system
by first bolting the two inlet resonator assemblies to the
vehicle catalytic converters. Use the supplied bolts to
loosely secure. Slip the inlet pipes of the X-Pipe
assembly over the outlets of both resonator assemblies,
loosely secure using the supplied clamps. Mount the
both driver and passenger side Tail Pipe Assemblies in a
similar fashion. Locate the welded hangers into the
OEM rubber insulators.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of frame
& bodywork. (MAGNAFLOW recommends at least 1/2"
of clearance between the exhaust system and any body
panels to prevent heat-related body damage or fire.)
Step 3: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight to
properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten if
necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15067
2011 - 2012 Dodge Durango 5.7L RT
Warning : When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Apr 12, 2013
Rev: 000
Reso. Sub Assy P/S.
Reso. Sub Assy D/S.
4X M10 Bolts
4X 2.50" Clamps
Tail Pipe Assy D/S
Tail Pipe Assy P/S