MagnaFlow BMW 325ES Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions
before installation). To remove your OEM
exhaust system, begin by unbolting the exhaust
inlet flange from the catalytic converter and
remove the hangers from the rubber insulators
making sure to retain all hardware as it will be
needed to install your new MAGNAFLOW
performance exhaust system.
Step 2: Install your new exhaust system by
fastening the Resonator Assembly to the
catalytic converter and locate the hanger to the
rubber insulator. Next, slip the inlet of the
Muffler Assembly over the outlet of the
Resonator Assembly and use the supplied
clamp to secure. Use OEM hardware to secure
the Muffler Assembly.
Step 3: With all components mounted loosely,
adjust the system for overall aesthetics and
clearance of frame & bodywork. (MAGNAFLOW
recommends at least 1/2" of clearance between
the exhaust system and any body panels to
prevent heat-related body damage or fire.)
Step 4: Once a final position has been chosen
for the new system, evenly tighten all fasteners
from front to rear. The supplied band clamps
must be VERY tight to properly align the pipes
and prevent leaks (Approximately 40ft-lbs).
Inspect all fasteners after 25-50 miles of
operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
16536
1984-1987 BMW 325E 2.7L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
06/28/13
Rev: 000
Muffler
Assembly
Resonator
Assembly
2.25" Clamp