MagnaFlow MITSUBISHI LANCER Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) Remove the OEM system by unbolting
the flange located behind the catalytic converter and
the flange located near the muffler inlet. Carefully
remove the OEM system making sure not to damage
any of the original mounting hardware or rubber
isolators, as they will be needed to install your new
MAGNAFLOW system.
Step 2: Attach the Inlet Pipe Assembly at the flange
junction using the OEM fasteners. Working front to
rear install the rest of the new system by locating the
hangers into the appropriate OEM isolator and by
using the supplied clamps.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 65ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15597
2009 Mitsubishi Lancer Ralliart 2.0L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Sep 13, 2010
Rev: 000
Inlet Pipe
Mid-Pipe
Muffler
Assembly
2X 3.00"
Clamp