beautypg.com

MagnaFlow BMW 435I Stainless Cat-Back System PERFORMANCE EXHAUST User Manual

Page 3

background image

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905

Technical Support: 1(800) 959-9226 | Email: [email protected]

Step 6.

Once a final position has been chosen for

the new 6system, evenly tighten all clamps from
front to rear using the torque specifications on page
one of the instructions. Inspect all fasteners after
25-50 miles of operation and re-tighten if necessary.

Step 5.

Lastly, install the Extension Pipe and

Muffler Assembly by fitting the hangers into the
rubber insulators and fasten using the supplied
3.00" clamps. Plug the wire connector into the servo
motor install factory braces.

Step 4.

Next fasten the Resonator Assembly to

the inlet pipe using the supplied 3.00" clamp.