MagnaFlow MINI COOPER Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions
before installation)
Disassemble the old system
from the vehicle, take care to retain the original
mounting harware and rubber insulators for re-use.
Step 2: Lay out all components of your new
MAGNAFLOW exhaust system before you start the
installation process. Install the system working from
front to rear of the vehicle. Use the supplied 2.25"
U-Bolt clamp for the Inlet Pipe to the converter. Use
the 2.50" TORCA clamp for the Inlet Pipe to the
Muffler Assembly.
Step 3:
With all components mounted loosely,
adjust the system for overall aesthetics and clearance
of frame & bodywork. (MAGNAFLOW recommends
at least 1/2" of clearance between the exhaust
system and any body panels to prevent heat-related
body damage or fire.)
Step 4:
Once a final position has been chosen for
the new system, evenly tighten all fasteners from
front to rear. The supplied band clamps must be
VERY tight to properly align the pipes and prevent
leaks (Approximately 40ft-lbs). U-bolt clamps should
be tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15207
2012 Mini Cooper S Coupe 1.6L Turbo
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
03/18/13
Rev: 000
Muffler Assy
2.50" Torca
Clamp
Muffler Assy
U-Bolt
Clamp