MagnaFlow VOLKSWAGEN BEETLE Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) Begin removal of the OEM exhaust
system by loosening the OEM clamp located behind
the catalyst converter. Do not damage or discard the
OEM clamp nor rubber insulators, as they will be
reused to mount the new system. Disengage the
welded hangers from the OEM rubber insulators and
remove the entire OEM exhaust system.
Step 2: Install the new exhaust system by using a front
to rear method. Using the OEM clamp, install the inlet
pipe assembly, then insert the welded hangers into the
OEM rubber insulators. Leave all clamps loose for the
final adjustment of the complete system. Using the
supplied 2.50" clamp, install the tailpipe muffler
assembly in a similiar fashion.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). U-bolt clamps should be
tightened to approximately 30-35ft-lbs. Inspect all
fasteners after 25-50 miles of operation and retighten
if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15061
2012 Volkswagen Beetle 2.0L Turbo
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
Jul 13, 2012
Rev: 000
Inlet Pipe Assy.
Tail Pipe Muffler Assy.
2.50" Clamp