Wyred 4 Sound MS User Manual
Page 3

Special notes
- CDs must be inserted into the server LABEL SIDE DOWN.
- Take Caution to power the server down by a quick press of the power button. Do not unplug
the server while it is powered on or press and hold the power button to shut down.
- We highly recommend backing up your hard drive contents to an external hard drive on a
regular basis to prevent loss of data. Wyred 4 Sound is not responsible for any information lost
in the event of a component failure.
-If the server is not connected to the Internet when ripping CDs it will be unable to locate
tagging information and album artwork.
Package contents
● 1 – Music Server
● 1 – Power Supply
● 1 – User Manual CD
Getting connected
1. Place the Server in the intended location and ensure that it has proper ventilation. We
recommend that if you are placing it in an enclosed cabinet, it is not on or near any other
component that produces excessive heat.
2. Connect the power supply to the wall outlet and then to the Server high current jack on the
left side of the rear panel.
3. Next connect an Ethernet cable from your router to the Ethernet port on the rear panel of the
server. (If you do not have a router in the same room as your system and do not wish to run
Ethernet, there are several alternative options. Please contact the place of purchase for the
best alternatives.)
4. Connect the appropriate digital output to your DAC using the appropriate digital cable. The I²S
output is not a standard HDMI format output and is configured for the Wyred 4 Sound DAC-2
5. Power the unit on by pressing the power button located on the right side of the front panel.
When turning the unit off use a quick press of the power button. It will shut down in less than
30 seconds. Do not press and hold the power button to shut it down.
(Power “on” is indicated by blue ring light, green indicates the unit is in standby)
6. Proceed to the appropriate section for configuring the server for your desired use and enjoy!
pg.
3