WebDT DT313H/DT315CT/ DT365/ DT395/ DT398B/ DT398C Modules BOG (Win7/ WES7) - Manual (Page 4)

www.dtresearch.com
Mobile POS Tablet
Magnetic Stripe Reader
Magnetic Stripe Reader 1/2
To Connect Magnetic Stripe Reader Module
To connect the Magnetic Stripe
Reader, use the Keyboard Wedge.
Tap on the
icon in the task
bar, a menu is displayed as shown
in the picture to the right. Choose
Connect MSR.
To Configure MSR
For a magnetic stripe card, the raw data in each data track may contain start and end
sentinel characters. To remove those characters, you can select the MSR Setting command
to parse input raw data and filter out the start and end sentinel characters on each track.
Click 1. MSR setting in the WebDT Keyboard Wedge menu, and the Msr Parse Format
Setting window will be displayed.
Choose Enable in the Parse Data section. 2.
Choose data you want to parse at the
start or end of each track.
For Example:
Check Track 1
• In Start Sentinel Character, select %
• In End Sentinel Character, select ?
Click 3. OK to complete the settings
MSR connected
DATA CAPTURE MODULE OPERATION GUIDE
To Test Magnetic Stripe Reader Module
Click 1. Start | All Programs | Accessories | NotePad to run the Notepad.
Swipe a magnetic stripe card through the module. The output will appear in the NotePad 2.
screen.
Verify the captured data.
3.