The dt395 – WebDT DT395 User Manual
Page 2
DT395
ENGLISH
2
Button Functions
BUTTON
ACTION
Programmable
Programmable, launch soft (on-screen) keyboard (default)
Launch SAS (Secure Attention Sequence)
Generate Ctrl+Alt+Del keys to invoke the security windows defined under Windows XP
Programmable,
Calibrate touch screen before logging in to the operating system
Change display orientation (portrait/ landscape) (default)
Programmable, system utility menu (default)
Programmable,
As scanner trigger when equipped with the scanner module
Power on,
Push/release typically enters Standby mode, or Push/release exits Standby mode or
restarts (software dependent)
Push and hold (over 4 seconds) invokes hardware shutdown
The DT395
Battery/Power LED
Wireless LED
1
8
9
2 3
4
5
6
8
9
7
Input/ Output Ports
Wireless Switch
Headphone Jack
USB Port
DC Power Input
Full Slot Smart Card Reader and SD Card Reader
A
C
D
E
B
A
B
C
D
E
1
2
3
4
5
6
7
Button Management
Where supported by software, many of the hard buttons on the DT395 are programmable
to perform a function of the user’s choice. The exception is the Power Button and the
SAS Button. To activate the button re-assignment application, invoke the Button Manager
application
.
Brightness Control
Where supported by firmware and software, a hard button may be engaged to
manipulate the display brightness. Press the System Utility Menu button (Button 7) on the
front of the DT395. The System screen will display a Brightness control section with up
and down arrows that can be activated with the stylus.
Battery and Power Management
The DT395 is equipped with an internal Li-Ion battery pack and an optional battery
pack that clips (hot-pluggable) onto the back of the tablet. The period between battery
recharges can be significantly lengthened by putting the tablet into Standby mode
through the Power Button (see Buttons Function Table) whenever the tablet is not in use.
Depending on the operating software, the DT395 may also be configured to enter various
power-saving modes via the Power Button or through timed entry.
Full Slot Smart Card Reader and SD Card Reader
The DT395 comes with a full slot smart card reader.
Remove the rubber cover and insert a card (Picture 1).
•
Pull to remove the card (Picture 2).
•
Remove the rubber cover and insert a SD card (Picture 3).
•
Push, release and remove the card (Picture 4).
•
(Picture 1)
(Picture 3)
(Picture 2)
(Picture 4)
3
ENGLISH