WebDT DT307SQ - Manual (Page 2)

DT307SQ
ENGLISH 2 3 ENGLISH
If your DT307SQ comes with a Barcode Scanner, RFID Reader and/or MSR module(s), you
may refer to the steps below to configure the settings.
BASIC MODULE OPERATION
3 steps to capture the data results from Keyboard Wedge:
Turn on module from the 1. Keyboard Wedge App
Launch a note-related App 2.
Capture the data and verify the results 3.
BARCODE SCANNER
Launch the scanner module, and adjust the parse data format :
Tap the 1. Keyboard Wedge App , select SCAN tab, and turn on the Scanner module
Key in Prefix and Suffix codes to adjust the parse data format 2.
Click 3. Apply
NOTE: To ensure the system performance, turn on only the symbologies you are
going to use.
DT307SQ I/O Ports
DT307SQ LED Status Indicators
1. Power Mode Status Indicator:
2. Wi-Fi Status Indicator:
Blue: Device is powered on
•
Blinking Blue: Main battery charging
•
Orange: Low battery mode
•
Blinking Orange: Extremely low battery mode
•
Off: Device is powered off or in suspend mode
•
Blue: Connected to a wireless AP
•
Blinking blue: Connecting to a wireless AP
•
Off: Wi-Fi is disabled
•
A G
B H
C I
D J
E K
L F
Magnetic stripe reader (Optional)
Trigger button
Camera (Optional)
LED Flash (Optional)
Power button
Battery switch Micro-SD card reader
Speaker
mini USB port
Headphone-out
USB 2.0 port
DC-in
DT307SQ Front View
DT307SQ Side View DT307SQ Rear View
A
C D E
F G H
B
I
A
J
K
L
Data Capture Module Operation Guide
Add/ remove barcode symbologies
Tap 1. Barcode Scanner App
Turn on/off each barcode symbologies under 2. SYMBOLOGY tab