Waldorf Pulse 2 - Manual (Page 43)

Additional Settings
43 Pulse 2 User Manual
[ After you have bought your 127th Pulse 2, please
contact Waldorf Music. You will receive a perso-
nal device number that authorizes you to have
dinner with our Managing Director. Be sure we in-
vite you for some french fries at our favorite burger
company.
Input Gain -13...+20dB
Determines the sensitivity of the external audio input.
For high level signals the Input Gain should be reduced,
for low level signals increased.
w
Microphones or guitars can be directly connected
to the Pulse 2, but we recommend to use a suited
pre ampflifier. Low signal level instruments
should be amplified by a special pre-amplifier
before they are routed to the Pulse 2 External In.
P1 Legacy OFF / ON
Activates the controller assignment of the former Pulse 1
model.
w
By default, Pulse 2 do not map MIDI controllers
from 32 to 43 which are reserved by MIDI . With
P1 Legacy
mode, you can use them as they we-
re used on original Pulse.
LCD Contrast 0...127
Sets the display contrast.
CV Mode V/OCT / V/Hz
Selects the desired CV mode:
• V/OCT selects 1 Volt per Octave (exponential
scale).
• V/Hz selects Volt per Hertz (linear scale).
w
Hint: CV ranges from 0 to 5 Volt.
CV Amp PITCH / UNIPOL / BIPOL
Determines the CV output:
• If PITCH is selected, pitch will be send via CV
when a note is played or the arpeggiator gene-
rates notes.