Waldorf Zarenbourg - Manual (Page 18)

18
Store +
Plug
Saving Sounds
You can store your own sounds in 21
locations A1 – C7. To save the current
sound, press and hold the User Bank
button
[12] of the bank (A, B or C)
where you want to store the sound and
wait until it flashes. Select the your
desired location using the Sound Se-
lector
[11]. Then when you release the
button, the active sound is perma-
nently stored in your newly selected
location. As long as the button is held,
you can still chose another bank by
pressing another User Bank button
[12] and releasing the first one. You
can also cancel the store operation by
pressing the Preset Bank button [10] in
case you change your mind while the
button is already flashing.
Connecting to Mixer, Amplifier
or
Recording Device
Use the Line Out jacks for left and right
signal
[31| 32] or a single stereo cable
with just the left Line Out jack [31].
When the left Line Out [31] is not con-
nected, you can take a Mono signal
from the right Line Out right jack
[32].
Connection of Digital Output
Use the S/PDIF digital out [26].
Connecting to a Computer
Connect Zarenbourg to your computer
using an the USB jack
[25]. Zaren-
bourg is recognized as a class comp-
liant USB MIDI Device, so no drivers
are necessary. With the appropriate
software, you can now play, record or
backup the sound programs of your
Zarenbourg. You cannot transfer sam-
ple content or firmware through USB.
Instead, this is done using the SDHC
slot [21].