Vortech 1994-1995 Ford 5.0 Mustang User Manual

Page 9

P/N: 4FG020-010

04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))

A. Disconnect the battery negative cable.

Remove all of the components that lead to the

throttle body including the mass air flow (MAF)

sensor, air filter assembly and rubber bellows.

Separate the MAF sensor from the air filter as-

sembly and set aside.

C. Remove the air temperature sensor from the bel-

lows.

D. Loosen the crank pulley and water pump pulley

bolts.

E. Remove the accessory belt.

F. Remove the relay box that is mounted next to

the radiator recovery tank. Carefully remove the

electrical plug and set aside.

G. Remove the water pump pulley.

H. Drain approximately one gallon of coolant from the

radiator. Remove the upper radiator hose and set

aside.

I. Remove the belt tensioner assembly.

Unplug the wire connections and remove the

alternator assembly (make sure the battery is

disconnected).

Remove the smog pump hoses from the smog

pump.

L. Remove the smog pump and alternator brackets

with the smog pump still attached.

M. Remove the smog pump from the bracket.

N. Remove the 5/8" heater hose that runs from the

water pump to the manifold tube assembly, next

to the water temperature sender (see Fig. 1-a).

O. Remove the distributor shield and the passenger

side spark plug wires at the distributor and set

aside.

P. Disconnect the water temperature sensor plug.

Q. Carefully cut the steel tube that runs along the

intake manifold (the tube where the hose was pre-

viously removed). Remove approximately 3-1/4"

and discard the cut off piece (see Fig. 1-b).

R. Remove the radiator cover by using a Lisle door up-

holstery remover tool and a phillips screwdriver.

S. For component clearance, it is necessary to remove

the air conditioning line clamps on the frame and

tuck the hose on top of the frame rail.

T. Remove the "S" shaped coolant hose that runs

from the firewall to the steel tube above the in-

take manifold that was previously shortened (see

Fig. 1-c).

MODIFIED WATER

TUBE END

NOTE:

Refer to your Mustang Owner's Guide for

helpful illustrations and descriptions of particular

components.

1. PREPARATION/REMOVAL

Fig. 1-b

Fig. 1-c

FIREWALL

REMOVE HOSE

FROM

TEMPERATURE

SENDER/INTAKE

MANIFOLD

FROM WATER HOSE

VALVE COVER

(RIGHT SIDE)

WATER TUBE LEADING TO FIREWALL

WATER NECK

REMOVE

HOSE

WATER

PUMP

Fig. 1-a