Vortech 1994-1995 Ford 5.0 Mustang User Manual

Page 18

P/N: 4FG020-010

04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))

F. Slide the 3-1/8" x 1" sleeve onto the stock mass

air sensor. Slide the flex hose and #52 hose clamp

over the assembly.

G. Mount the hose and mass air assembly onto the

mounting bracket using the four 1/4-20 bolts,

washers and nylock nuts.

h. Screw the air temperature sensor into the bracket

and plug in the electrical connector for the MAF

and the air temp sensor.

I. Slide the air filter and clamp assembly onto the

bracket and secure.

INLET DUCT

A. Slide the inlet duct along with the T-type clamp

onto the supercharger inlet. (See Fig. 13-a.)

B.* Place the oil drain hose onto the supercharger drain

fitting and secure with a hose clamp. Arrange the

clamp screw housing so it will not interfere with

the mounting plate when installed.

C.* Feed the oil drain hose around the side of the

smog pump and down towards the oil pan fitting

while lowering the supercharger into position.

D. Secure the supercharger with four (4) 3/8-16 x 1"

bolts and AN washers.

E.* Connect the lower end of the oil drain hose to the

fitting on the pan and secure with a hose clamp.

Drain must be routed downhill with no kinks or

dips. Trim hose if necessary.

F. Place the supercharger belt idler assembly on the

supercharger using the 12mm bolts and washers.

Position the thin head bolt in the tensioner plate

nearest the idler pulley.

G. Attach the 3-1/2" elbow assembly and 3-1/2 x 2"

sleeve to the supercharger inlet duct using the

#56 clamps. Route the flex hose end through the

opening in the fender apron and attach to the

MAF sensor outlet. Secure hose to MAF with the

supplied #52 clamp.

h.**Secure the remote drain hose away from the belt

and other hoses using tie-wraps.

13. SUPERCHARGER MOUNTING AND ASSEMBLY, HOSE DRAIN AND INLET DUCT

Fig. 13-a

12. MASS AIR FLOW SENSOR RELOCATION cont'd.

* Applies to "engine oil-fed" units only. V-3 applications

skip these steps.

** Applies to V-3 applications only