T-rex, Fuel pump installation cont'd – Vortech 1994-1995 Ford 5.0 Mustang User Manual

Page 23

P/N: 4FG020-010

04NOV08 V2.0(94-95 5.0 Mus.(4FG V2.0))

18. T-REX

FUEL PUMP INSTALLATION cont'd.

NOTE:

Make sure everything is secure and away from all moving parts

or exhaust pipes. Make sure no wires will rub on sharp edges.

After you have activated the pump, check for any leaks and

correct if necessary.

Fig. 18-a

T-REX

MAGNIFICATION OF RELAY WIRING

GROUND

RELAY

87A

(+)T-REX FUEL PUMP

RED/PURPLE WIRE

IN STOCK HARNESS

LUG FROM BATTERY

TO FUSE PANEL

UNDER HOOD

Route the red power lead from the relay #30 under the car through the drive shaft

tunnel and secure with ties! Take care to avoid sharp edges and not damage the

wire insulation. Mount relay in the right rear corner of the spare tire well. Make sure

all wires are connected as per the relay schematic below. Provide a good ground

connection free of rust and paint for both the pump and relay.

(Check with test light when key is

turned to “ON” position. Test light

should illuminate for 2-3 seconds,

then it should turn “OFF”

automatically.)

5/16" x 16-1/2" HOSE

MAGNIFICATION - UNDERSIDE VIEW

FUEL TANK STRAP

T-REX FUEL PUMP

3/8" x 22" HOSE

11" CABLE TIES

CABLE TIE

FLEX LOOM

FROM FUEL

TANK

FRONT OF CAR

STOCK HOSE

ASSEMBLY

FROM TANK

FLOW

STOCK FUEL FILTER

AND BRACKET

FLOW

FRONT

OF CAR

20 AMP

INLINE

FUSE

HIGH CURRENT

FUSE PANEL

WITH POWER

LUG FROM

BATTERY

DRIVE

SHAFT

TUNNEL

SPARE

TIRE WELL

Pump is mounted below the tire well, under the car.

Secure wires with adhesive anchors and tie wraps.