Vortech Ford Driver's Side Renegade System User Manual

Page 13

P/N: 007062

28JAN03 v2.0

(DS Rngde S/C Sys(7062 v2.0))

A. From the stock radiator hose, make a 90

elbow

by trimming as shown. Also, cut a 2-1/2" long
straight piece from the stock hose and attach to
the upper radiator tank.

B. Remove the factory thermostat housing and

replace with the supplied 45

unit, gasket and

hardware.

C. Place the stainless steel water pipe between the

two hoses placing the shorter leg nearer the
radiator.

D. Position the hoses and tube so there is ample

overlap for sealing, and secure with provided
clamps.

E. Refill radiator and coolant bottle.

RADIATOR HOSE & THERMOSTAT HOUSING

Fig. 9-a

3”

THERMOSTAT

HOUSING

10.

FINAL CHECK

A. Reconnect the battery.
B. Check all fittings, nuts, bolts and clamps for

tightness. Pay particular attention to oil and fuel
lines around moving parts, sharp edges and
exhaust system parts. Make sure all wires and
lines are properly secured with clamps or tie
wraps.

C. Check all fluid levels.
D. Start engine and allow to idle a few minutes,

then shut off.

E. Recheck to be sure that no hoses, wires, etc. are

near exhaust headers or moving parts and for
signs of any fluid leakage.

F. PLEASE TAKE SPECIAL NOTE: Operating

the vehicle without ALL the subassemblies com-
pletely and properly installed may cause FAIL-
URE OF MAJOR COMPONENTS.

G. Test drive the vehicle.

WARNING:

Do not attempt to operate the vehicle

until ALL components are installed and

ALL operations are completed including

the final check.