Vortech Ford Driver's Side Renegade System - Manual (Page 11)

P/N: 007062
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN03 v2.0 (DS Rngde S/C Sys(7062 v2.0))
A. Route the accessory belt as shown. Tension
the belt by rotating the alternator and tight-
ening the upper bolt and pivot.
B. Before installing the supercharger pulley
onto the supercharger, make sure that the
input shaft is lightly lubricated with a very
small amount of grease or oil. Insert the
supplied key into the keyway and slide onto
the supercharger shaft. Secure the pulley
onto the supercharger using the supplied
retainer, 3/8-24 bolt and AN washer. (A
A. Attach the Vortech aluminum
bracket and billet aluminum "3-
hole" spacer (the spacer must
go between the bracket and
cylinder head) to the right side
cylinder head using the sup-
plied hardware. Make sure that
each fastener uses the proper
AN washer, unless noted oth-
erwise (see graphic).
B. Attach the lower and upper alternator
tabs to the bracket and mount the alter-
nator. Thread the supplied 3/8-16 x 1"
bolt and SAE washer through the back of
the upper alternator tab to the alter-
nator. (This is used to secure the unit
after tensioning the belt.)
C. Tighten all brackets to the head bolts
and reattach electrical connection to the
alternator.
5
8. SUPERCHARGER/ACCESSORY DRIVE BELTS
NOTE: The supercharger pulley should be a
slip fit at 70
°
F. If pulley-to-shaft fit is
tight, slightly heat the pulley until it
slips easily onto the shaft. At NO point
should the pulley be hammered or pried
off or onto the shaft.
Fig. 7-a
ALTERNATOR
UPPER
ALTERNATOR
STAY
3/8-16 x 1” BOLT
& SAE WASHER
7/16-14 x 5-1/2” BOLT 3/8-16 x 1” BOLT
3/8-16 x 3-1/4” BOLT
3/8-16 x
5-1/4” BOLT
ALTERNATOR
BRACKET
5/16-18 x 1” BOLTS
3/8-16 x 5-1/4” BOLT & NUT
LOWER
ALTERNATOR STAY
VORTECH
4FP010-010
1.309
BELT TENSIONER
ARBOR
FRONT PLATE
SUPERCHARGER
MOUNTING
BRACKET
1/2-20 JAM NUT
(DO NOT TIGHTEN
UNTIL LAST STEP)
BEARING PILOT,
Ø.515 I.D.
IDLER
ADJUST
SCREW
BRACKET
IDLER
ADJUST
SCREW
IDLER
SPACER
Ø.515
IDLER
PULLEY
Ø4.0
1/4-20 x .75
SCREW
PLATE SPACER (5 TOTAL)
.218
.320
small drop of blue Loctite is recommended
on the bolt threads.)
Fig. 6-d
6. SUPERCHARGER MOUNTING, Cont'd.
VIEW FROM DRIVER'S SIDE
7. ALTERNATOR MOUNTING