Vortech Ford Driver's Side Renegade System User Manual

Page 10

P/N: 007062
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN03 v2.0

(DS Rngde S/C Sys(7062 v2.0))

SUPERCHARGER MOUNTING

A. Place the oil drain hose onto the supercharger

drain fitting and secure with a hose clamp.
Arrange the clamp screw housing so it will not
interfere with the mounting plate when installed.

B. Secure the supercharger to the mounting plate

with eight 3/8-16 x 1" bolts and AN washers.
(See

Fig. 6-a.)

C. Attach the supplied belt tensioner hardware to

the plate as shown in

Figs. 6-b, 6-d.

D. Attach the supplied front mount plate and 1.309"

spacers to the supercharger mounting plate
and supercharger as shown in

Fig. 6-b.

E. Attach the supplied 4" idler as shown in

Fig.

6-d).

F. Connect the lower end of the oil drain hose to

the fitting on the pan and secure with a hose
clamp. Trim hose length if necessary. (It is
VERY important that the hose has NO dips or
kinks.)

G. Attach the supplied 1/8" NPT x 45

flare fitting

and oil feed hose to the oil feed fitting on the
supercharger. When tightening the fitting, use a
1/2" wrench on the oil feed base for support.

WARNING:

When threading the 1/8" NPT x 45

flare fitting into the supercharger,

use engine oil on the pipe threads

for lubrication. Teflon tape, paste

or other sealant is NOT recom-

mended as it might loosen and

cause blockage of the oil feed ori-

fice, resulting in supercharger fail-

ure.

M12 X 1.75 x 20
w/WASHERS (3 PLACES)

3/8-16 x 2.75 HEX HD w/WASHER (5 PLACES)
1.309" SPACERS LOCATED BETWEEN S/C
MOUNTING PLATE AND FRONT PLATE

IDLER ADJUST SCREW

BELT TENSIONER ARBOR

1/4-20 x .75 SCREW

SUPERCHARGER MOUNTING PLATE

FRONT

PLATE

S/C BELT

IDLER/TENSIONER

3/8-16 x 1" HEX HD

w/WASHER (8 PLACES)

Ø.750 x 1.309" SPACERS (5 PLACES) TO BE SANDWICHED

BETWEEN S/C MOUNTING PLATE AND FRONT PLATE

Fig. 6-a

Fig. 6-b

Fig. 6-c