Vortech 1993-1996 5.2L Grand Cherokee User Manual

Page 23

15. PLENUM AND DISCHARGE INSTALLATION

THROTTLE

BODY

SIDE VIEW

(2) 1/4" WASHERS

FACTORY
AIR CLEANER
MOUNTING STUD

A. Remove the tab holding down the

factory air cleaner mounting stud. Use
the two (2) supplied 1/4" washers as
spacers underneath the mounting stud
tab. Reattach the assembly to the
throttle body. (See graphic.)

B. Place the gasket and plenum onto the

throttle body. Secure with plenum nut.

C. Fit the 3" x 2" silicone sleeve onto the

plenum and slide on the two #48 clamps.

D. Slide the 2-3/4" x 2" sleeve onto the

supercharger discharge. Secure with
#44 clamps.

E. Install the discharge tube between the

plenum and supercharger and secure
with clamps.

16. BYPASS VALVE INSTALLATION

A. Slide the 1" x 3-1/2" hose onto the

bypass valve. Secure with #16 hose
clamps. (See the graphic on the next
page.)

B. Slide the 1" x 2-1/2" hose onto the

discharge duct and bypass valve inlet.
Secure with hose clamps.

C. Route the 5/32" vacuum line to the

bypass valve and FMU tee as shown in
the graphic on the next page.

D. Using the supplied tee and length of

hose, cut the hose 4" from the FMU.

E. Install the tee fitting and connect the

hose to the bypass valve.