VDO WR X2 - Manual (Page 17)

X2 VDO CYCLECOMPUTING 32
F I I F
www.vdocyclecomputing.com X2 33
D GB D GB
How to set the tyre size by selecting the tyre:
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing
C for 3 seconds gets
you back to function mode).
Using up/down go to
WHEELSIZE/SET.
Confirm with
M .
MEASUREMENT/KMH.
Confirm with
M or to
change to MPH.
WHEELSIZE/BIKE 1 (use to
go to setting for bike 2).
Confirm with
M .
WHEELSIZE/ TYRE SELECT.
Confirm with
M .
TYRE SELECT/SELECT.
Now select your tyres using
. Confirm with
M .
The confirmation question appears “Tyresize“/
SELECT OK? When the displayed tyre size matches
the one you want, confirm with
M .
The display confirms WHEELSIZE/SET DONE
Automatic return to SETTINGS/SELECT.
5.2.2 Setting using wheel circumference >>> P05
To enter the wheel size manually, you must first
measure the wheel roll circumference on your bike. Measuring wheel roll circumferences:
step 1 Precisely align valve on the front wheel
vertically to the ground.
Step 2 Mark this spot on the ground with a line
(e.g. chalk).
step 3 Push the bike forwards one turn of the
wheel until the valve is vertical to the ground
again.
Step 4 Also mark this spot on the ground.
Step 5 Measure the distance between the two
marks.That is your wheel circumference
(=roll circumference).
Step 6 Enter the wheel circumference measured
in this way into your VDO computer.
ATTENTION: If you have selected KMH display,
you must enter the wheel circumference in mm
(If MPH display is selected, enter the wheel
circumference in inches).
How to set the wheel size manually:
Using go to SETTINGS/
SELECT. Confirm with M
You are now in setting mode
(pressing
C for 3 seconds gets
you back to function mode)
Using go to WHEELSIZE/
SET. Confirm with M .
MEASUREMENT/KMH.
Confirm with
M or to
change to MPH.
WHEELSIZE/BIKE 1.
(use
to go to setting for
bike 2) Confirm with M .
Using go to
WHEEL-SIZE/MANUAL SET.
Confirm with
M .
BIKE 1 ...SET SIZE/CONTINUE
Now set the wheel roll circum-
ference measured using
.
Confirm the entry with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: WHEELSIZE/SET DONE.
Automatic return to SETTINGS/SELECT.
Attention: The factory settings for bike 1 = 2155
mm and for bike 2 = 2000 mm. If you do not enter
any wheel sizes, the computer works with these
factory settings. The values measured in this
way for speed, distance etc. can differ widely
from the actual values.