UVP TB-101 Selector Switch - Manual (Page 9)

10. The side reflector panels must be aligned with the main reflector panel during reinstallation.
a. A small metal tab (a) protrudes from the side reflector panel at a 90° angle. This tab
must slide on the inside (the bulb side) of the main reflective panel.
b. Another portion of the side reflector panel is bent at a tight 180° angle to create a
180° angle tab (b). This must be aligned with a metal tab protruding from the outside
(non-bulb side) of the main reflective panel.
11. As the edges of the side reflector panels are sharp, ensure that all wiring is moved out of the
way during installation of the side reflector panels to avoid cutting into the sheathing of the
wiring. Slide the side reflector panels into place until the top edges of the reflector panels are
flush with the top edges of the main reflector panel.
180° Metal
Tab (b)
90° Small
Metal Tab (a)
Back Side of
Transilluminator
Main
Reflector
Panel