UVP TB-101 Selector Switch User Manual

Page 3

6. Inside the unit, locate the

side reflector panels which are two reflective metal panels located

at each end of the transilluminator light tubes. Note how these panels are installed prior to

removal, as this will aid with reinstallation later on.

7. Pulling straight up, remove the two side reflector panels from inside the transilluminator.

8. Looking inside the front panel of the transilluminator body, locate the

back side of the

transilluminator selector switch. Trace the wires from the back of the switch to the gray

wiring junction block located at the front-left corner of the unit. Note which wires are

connected from the switch to the junction block.

Side

Reflector

Panel

Back Side of

Selector

Switch