Two Notes VM-202 - Manual (Page 26)

Configuring and using the Torpedo VM-202
4.3 Midi
• Channel : Select here the MIDI Channel you want the VM-202
to respond to. When "All" is selected, the VM-202 responds to all
the channels (omni mode). All the signals received at the MIDI
input are sent on through the "MIDI OUT/THRU" output.
• Control Change : "On" position means that the VM-202 re-
sponds to CONTROL CHANGE messages
• Program Change : "On" position means that the VM-202 responds to PROGRAM CHANGE messages
4.4 System
• Brightness : Set the brightness of the display.
• Firmware : Gives information about the current firmware version
in the unit.
4.5 Device ID
• Device ID : This menu lets you give an identifying name to your
machine. You will have to give different Device IDs to several
machines connected simultaneously in USB to the same com-
puter if you want to control them with the Torpedo Remote soft-
ware. Move through the alphabet using the "NAVI" knob and
select the letters with "OK". after a change in the Device ID, you
will have to reboot the VM-202
26 Two Notes Audio Engineering Torpedo VM-202